Raritan Computer CCA-0N-V5.1-E User Manual download pdf (Page 253)

Chapter 14: System Maintenance

235

Restarting CC-SG after Shutdown

After shutting down CC-SG, use one of these two methods to restart the

unit:

 Use the Diagnostic Console. See Restart CC-SG with Diagnostic

Console (on page 315).

 Recycle the power to your CC-SG unit.

Powering Down CC-SG

If CC-SG loses AC power while it is up and running, it will remember the

last power state. Once AC power is restored, CC-SG automatically

reboots. However, if CC-SG loses AC power when it is powered off, it will

remain powered off when AC power is restored.

Important: Do not hold the POWER button to forcibly power down

CC-SG. The recommended way to power down CC-SG is to use the

Diagnostic Console's "CC-SG System Power OFF" command. See

Power Off CC-SG System from Diagnostic Console

(on page 317).

To power down the CC-SG:

1. Remove the bezel and firmly tap the POWER button.

2. Wait approximately one minute while CC-SG gracefully powers

down.

Note: Users logged into CC-SG via Diagnostic Console will receive a

short broadcast message when the CC-SG unit is powered down.

Users logged into CC-SG via a web browser or SSH will not receive

a message when the CC-SG unit is powered down.

3. If you must remove the AC power cord, let the power down process

finish completely before removing the power cord. This is required

for CC-SG to complete all transactions, close the databases, and

place the disk drives into a safe state for power removal.

Ending CC-SG Session

There are two ways to end a CC-SG Session.

 Log out to end your session while keeping the client window open.

See Log Out of CC-SG (on page 235).

 Exit to end your session and close the client window. See Exit

CC-SG (on page 236).

Log Out of CC-SG

1. Choose Secure Gateway > Logout. The Logout window opens.

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 419 420

No comments

Raritan Computer CCA-0N-V5.1-E User Manual Page 253